Pictures of the progress on the Monarch 10EE lathe. All photos after the serial number tag are of the lathe in its current condition. Work done listed below…
-General cleaning and scrubbing of the entire lathe, full fluid change
-Re-wired broken speed potentiometer, replaced bulged capacitor
-Replace all oil metering units with new and rebuild oil pump. Flushed apron and all oil lines
-Replaced all drive belts, replaced bearings in idler pulleys, flushed back gear gearbox
-Replaced old module drive unit with new modern solid state module
-Replaced worn out ELSR components such as felt seals, worn key, steel wipers, etc.